This is a working overview of Sublimation, written for readers who want more than a one-paragraph summary but less than a textbook.
Reviewed 2026-07-24. Anything still debated is marked as such rather than presented as settled.
After lyophilization, a product's quality depends on residual moisture, cake appearance, and reconstitution time. Residual moisture is often measured by Karl Fischer titration or thermogravimetric analysis. A low moisture content can slow chemical degradation, but overly dry cakes may be brittle or slow to dissolve. Stability studies track these attributes over months under defined temperature and humidity conditions. Batch records link these measurements to specific process runs and help identify trends before a product fails specification.
Storage conditions for dried products usually aim to exclude moisture and oxygen. Vials are sealed under vacuum or with an inert gas, and stoppers must maintain a barrier during transport. Temperature recommendations vary; some materials remain stable at room temperature, while others need refrigeration or frozen storage. Humidity control is critical because dried cakes can absorb water rapidly once a container is opened. Desiccant packs and moisture-barrier bags add further protection during shipping.
Lyophilization is a dehydration process that removes water from a frozen material by sublimation under low pressure. The material is first frozen so that water becomes ice; then the surrounding pressure is lowered below the vapor pressure of ice. Heat is applied gently so ice changes directly to vapor without passing through a bulk liquid phase. The vapor is collected on a cold condenser, leaving a dry porous matrix. This process differs from simple evaporation because the material remains frozen during the main drying stage.
The process usually has three stages: freezing, primary drying, and secondary drying. Freezing sets the ice crystal structure and can determine pore size in the final cake. Primary drying removes free ice by sublimation at low pressure and low shelf temperature. Secondary drying removes bound water by raising the shelf temperature, although some water may remain as part of the solid. Cycle parameters depend on formulation, fill volume, vial type, and equipment performance.
| Property | Value | Notes |
|---|---|---|
| Appearance | Porous solid cake | Typically white to off-white; varies with formulation |
| Reconstitution time | Seconds to several minutes | Depends on cake porosity and solute |
| Residual moisture | 0.5-3% w/w | Measured by Karl Fischer titration |
| Storage temperature | Room temperature to -20 °C | Product-specific; humidity-controlled |
| Common quality attribute | Cake elegance | Visual check for collapse, shrinkage, or meltback |
Stability of a lyophilized product depends on its glass transition temperature, the temperature at which the amorphous cake transitions from a glassy to a rubbery state. Storage below this temperature minimizes molecular mobility and slows chemical degradation. If the storage temperature exceeds the glass transition temperature, the cake may collapse, shrink, or become sticky. Accelerated stability studies at elevated temperatures and humidity help predict shelf life, but they do not always reflect real-time behavior. Residual moisture content also plays a critical role in long-term stability.
Reconstitution involves adding a suitable diluent, often sterile water or a buffer, to the dried cake. Gentle swirling or inversion helps dissolve the material without creating excessive foam. The time required for complete dissolution can range from seconds to several minutes and depends on the cake structure and the diluent. Improper reconstitution, such as vigorous shaking or using the wrong diluent, can cause protein aggregation or loss of activity. After reconstitution, the product may have a limited shelf life and should be used according to its labeling.
Freeze-drying is used for materials whose activity or structure depends on low temperature and low water content. Examples include certain biologics, diagnostic reagents, starter cultures, coffee, and porous inorganic precursors. The dried product forms a cake whose porosity aids rapid wetting and dissolution. Main drawbacks are high energy use, long cycle times, and sensitivity to formulation and equipment variation. Questions remain about how freezing rates and ice morphology affect batch uniformity, especially when moving from laboratory to production scale.
Lyophilization, also called freeze-drying, is a dehydration process in which a solvent, usually water, is frozen and then removed by sublimation under reduced pressure. The method preserves heat-sensitive materials that would degrade in conventional drying. Large-scale use grew during the mid-twentieth century for blood plasma and antibiotics, and it later expanded to vaccines, enzymes, foods, and advanced materials. The process produces a dry, porous solid that usually reconstitutes rapidly. It is distinct from simple evaporation because the solvent bypasses the liquid phase during primary removal.
The process generally proceeds in three stages: freezing, primary drying, and secondary drying. During freezing, controlled cooling converts water into ice and may also crystallize or vitrify solutes. In primary drying, the pressure is lowered below the triple point, and heat is supplied so ice sublimes directly to vapor. Secondary drying removes water that remains bound to the solid matrix, yielding a low final water content. Product temperature must stay below the collapse or glass transition temperature to maintain structure. Cycle design therefore balances shelf temperature, chamber pressure, and time.
TNF is a cytokine produced mainly by activated macrophages, and is the major extrinsic mediator of apoptosis. Most cells in the human body have two receptors for TNF: TNFR1 and TNFR2. The binding of TNF to TNFR1 has been shown to initiate the pathway that leads to caspase activation via the intermediate membrane proteins TNF receptor-associated death domain (TRADD) and Fas-associated death domain protein (FADD). cIAP1/2 can inhibit TNF signaling by binding to TRAF2. FLIP inhibits the activation of caspase-8. Binding of this receptor can also indirectly lead to the activation of transcription factors involved in cell survival and inflammatory responses. However, signalling through TNFR1 might also induce apoptosis in a caspase-independent manner. The link between TNF and apoptosis shows why an abnormal production of TNF plays a fundamental role in several human diseases, especially in autoimmune diseases. The TNF receptor superfamily also includes death receptors (DRs), such as DR4 and DR5. These receptors bind to the protein TRAIL and mediate apoptosis. Apoptosis is known to be one of the primary mechanisms of targeted cancer therapy. Luminescent iridium complex-peptide hybrids (IPHs) have recently been designed, which mimic TRAIL and bind to death receptors on cancer cells, thereby inducing their apoptosis.
Bruce Randall Donald (born 1958) is an American computer scientist and computational biologist. He is the James B. Duke Professor of Computer Science and Biochemistry at Duke University. He has made numerous contributions to several fields in Computer Science such as robotics, Microelectromechanical Systems (MEMS), Geometric & physical algorithms and computational geometry, as well as in areas of Structural Molecular Biology & Biochemistry such as Protein design, Protein Structure Determination and Computational Chemistry.
Antibodies have antigen-binding fragment (Fab) regions and constant fragment (Fc) regions. The Neutralization of virus infection occurs when the Fab regions of antibodies binds to virus antigen(s) in a manner that blocks infection. Antibodies are also able to "kill" virus particles directly and/or kill infected cells using antibody-mediated "effector functions" such as opsonization, complement-dependent cytotoxicity, antibody-dependent cell-mediated cytotoxicity and antibody-dependent phagocytosis. These effector functions are contained in the Fc region of antibodies, but is also dependent on binding of the Fab region to antigen. Effector functions also require the use of complement proteins in serum or Fc-receptor on cell membranes. Ansuvimab has been found to be capable of killing cells by antibody-dependent cell-mediated cytotoxicity.
Sources: en.wikipedia.org
The F1 fraction derives its name from the term "Fraction 1" and FO (written as a subscript letter "o", not "zero") derives its name from being the binding fraction for oligomycin, a type of naturally derived antibiotic that is able to inhibit the FO unit of ATP synthase. These functional regions consist of different protein subunits — refer to tables. This enzyme is used in synthesis of ATP through aerobic respiration. Located within the thylakoid membrane and the inner mitochondrial membrane, ATP synthase consists of two regions FO and F1. FO causes rotation of F1 and is made of c-ring and subunits a, two b, F6. F1 is made of α, β, γ, and δ subunits. F1 has a water-soluble part that can hydrolyze ATP. FO on the other hand has mainly hydrophobic regions. FO F1 creates a pathway for protons movement across the membrane.
The society publishes three research journals and a review journal: the Journal of Pharmacology and Experimental Therapeutics, Drug Metabolism and Disposition, Molecular Pharmacology, and Pharmacological Reviews Starting in 2012 these publications are only offered online. The society copublishes a wholly open access journal with the British Pharmacological Society and Wiley entitled Pharmacology Research & Perspectives. ASPET also publishes a quarterly newsletter, The Pharmacologist, and, from 2001 to 2011, Molecular Interventions magazine. The society gives out several awards:
A rare development is amyloid purpura, a susceptibility to bleeding with bruising around the eyes, termed "raccoon-eyes". Amyloid purpura is caused by amyloid deposition in the blood vessels and reduced activity of thrombin and factor X, two clotting proteins that lose their function after binding with amyloid. Amyloid deposits in tissue can cause enlargement of structures. Twenty percent of people with AL amyloidosis have an enlarged tongue, that can lead to obstructive sleep apnea, difficulty swallowing, and altered taste. Tongue enlargement does not occur in ATTR or AA amyloidosis. Deposition of amyloid in the throat can cause hoarseness.
Amivantamab, sold under the brand name Rybrevant, is a bispecific monoclonal antibody used to treat non-small cell lung cancer. Amivantamab is a bispecific epidermal growth factor (EGF) receptor-directed and MET receptor-directed antibody. It is the first treatment for adults with non-small cell lung cancer whose tumors have specific types of genetic mutations: epidermal growth factor receptor (EGFR) exon 20 insertion mutations. The most common side effects include rash, infusion-related reactions, skin infections around the fingernails or toenails, muscle and joint pain, shortness of breath, nausea, fatigue, swelling in the lower legs or hands or face, sores in the mouth, cough, constipation, vomiting and changes in certain blood tests. Amivantamab was approved for medical use in the United States in May 2021, and in the European Union in December 2021. The US Food and Drug Administration considers it to be a first-in-class medication.
Sources: en.wikipedia.org
2A peptides are a class of 18–22 aa-long peptides, which can induce ribosomal skipping during translation of a protein in a biological cell. These peptides share a core sequence motif of DxExNPGP, and are found in a wide range of viral families. 2A peptides can be introduced artificially to help generate polyproteins from a single ORF, by causing the ribosome to fail at making a peptide bond, and then resume translation. The members of 2A peptides are named after the virus in which they have been first described. For example, F2A, the first described 2A peptide, is derived from foot-and-mouth disease virus. The name "2A" itself comes from the gene numbering scheme of this virus. These peptides are also known as "self-cleaving" peptides, which is a known misnomer, because the missing peptide bond is never synthesized by the ribosome, and is thus not cleaved.
The Asilomar Conference on Recombinant DNA was an influential conference organized by Paul Berg, Maxine Singer, and colleagues to discuss the potential biohazards and regulation of biotechnology, held in February 1975 at a conference center at Asilomar State Beach, California. A group of about 140 professionals (primarily biologists, but also including lawyers and physicians) participated in the conference to draw up voluntary guidelines to ensure the safety of recombinant DNA technology. The conference also placed scientific research more into the public domain, and can be seen as applying a version of the precautionary principle. The effects of these guidelines are still being felt through the biotechnology industry and the participation of the general public in scientific discourse. Due to potential safety hazards, scientists worldwide had halted experiments using recombinant DNA technology, which entailed combining DNAs from different organisms. After the establishment of the guidelines during the conference, scientists continued with their research, which increased fundamental knowledge about biology and the public's interest in biomedical research.
Because protein chains are open, AlphaKnot uses closure procedures before applying knot invariants. Its probabilistic method repeatedly closes the chain using randomly selected points on a large surrounding sphere and assigns the dominant topology obtained from the ensemble of closures. Deterministic alternatives connect the chain termini using prescribed geometries, including a direct closure and a closure constructed using the centre of mass. Knot identification uses the HOMFLY polynomial to distinguish knot types. AlphaKnot recognizes knots with minimal representations containing up to 12 crossings. In large-scale database calculations, structures that exhibit evidence of a nontrivial knot are subsequently analysed to determine the corresponding knot core, the smallest portion of the protein chain required to retain the detected topology. The database primarily reports the topology of the complete protein chain. More detailed information about subchain topologies can be obtained by calculating a knot map, which records the topology of different portions of the sequence. Because producing full knot maps for hundreds of thousands of structures would require substantial computational resources, these calculations are performed on demand rather than precomputed for the entire AlphaFold DB v4 dataset.
Although the mechanism by which Hmd acts is unknown, the iron-containing cofactor is in part responsible for the catalytic activity. High concentrations of CO inhibit the enzyme as well, implicating iron as the center of catalysis. It has been proposed that the iron functions to bind H2 and the substrate methenyltetrahydromethanopterin, organizing these two reactants in close proximity.
Carnitine is an essential cofactor for mitochondrial transport of long‑chain fatty acids (a major lipid class) into the matrix for β‑oxidation. gamma-aminobutyric acid is a neurotransmitter. 5-HTP (5-hydroxytryptophan) is used for experimental treatment of depression. L-DOPA (L-dihydroxyphenylalanine) for Parkinson's treatment, Eflornithine inhibits ornithine decarboxylase and used in the treatment of sleeping sickness. Canavanine, an analogue of arginine found in many legumes is an antifeedant, protecting the plant from predators. Mimosine found in some legumes, is another possible antifeedant. This compound is an analogue of tyrosine and can poison animals that graze on these plants. However, not all of the functions of other abundant nonstandard amino acids are known.
Sources: en.wikipedia.org
Karl Fischer titration is a common reference method that quantifies water by a chemical reaction. Thermogravimetric analysis can also estimate moisture by weight loss on heating. Method choice depends on sample size and whether other volatile substances are present.
Cake collapse often occurs when the product exceeds its collapse temperature during primary drying. The frozen matrix loses structure and the ice channels close. Optimizing formulation and cycle parameters helps avoid this defect.
No. Storage temperature depends on the stability of the dried material. Some products are stable at room temperature, while others require refrigeration or freezing. Container integrity and moisture barriers also affect shelf life.
The main change is sublimation, in which ice becomes water vapor without melting into liquid water. This occurs when the chamber pressure is held below the vapor pressure of ice while mild heat is supplied. The result is a dry, porous solid that retains much of its original shape.